Product Details

Deep Grove Ball Bearing

A ball bearing is a type of rolling-element bearing that uses balls to maintain the separation between the bearing races.

The purpose of a ball bearing is to reduce rotational friction and support radial and axial loads. It achieves this by using at least two races to contain the balls and transmit the loads through the balls. In most applications, one race is stationary and the other is attached to the rotating assembly (e.g., a hub or shaft). As one of the bearing races rotates it causes the balls to rotate as well. Because the balls are rolling they have a much lower coefficient of friction than if two flat surfaces were sliding against each other.

Ball bearings tend to have lower load capacity for their size than other kinds of rolling-element bearings due to the smaller contact area between the balls and races. However, they can tolerate some misalignment of the inner and outer races.

MBP use improved ball quality to so to provide noise free bearings and smooth running 

MBP ball bearings have an optimized surface finish on all the contact surfaces to provide the sufficient  lubrications this allows the bearings to run cooler and last longer

Bearing No. d D T B C R Mass
6000 10 26 0 8 - - 0.01
6001 12 28 0 8 - - 0.02
6002 15 32 0 9 - - 0.03
6003 17 35 0 10 - - 0.03
6004 20 42 0 12 - - 0.06
6005 25 47 0 12 - - 0.08
6006 30 55 0 13 - - 0.12
6007 35 62 0 14 - - 0.16
6008 40 68 0 15 - - 0.19
6009 45 75 0 16 - - 0.25